15
1 Before Using This Product
No. 99MAF029B
5
Slowly bring the probe into contact with the following position on the ball diameter calibration block until
a beep sound is made.
6
Press .
»
The probe diameter setting is complete.
NOTE
• The actual dimensions of the sphere diameter and the measured value may not match.
• When measuring, calculates the diameter of the sphere and displays the result. The moment the
probe is brought into contact with the workpiece, a beep will sound, and the displayed value may
appear to jump, but this is not a malfunction.
To Next Page
Loading...
Need help?
General
