19
2 Basic Measuring Methods
No. 99MAF029B
2.2
Measuring the Width
Measure the steps and the width of the grooves. As an example, the procedure for measuring the step
of A (10 mm) and the groove width of B (30 mm), shown below, using a1 as the INC origin is explained.
a1
A (10 mm)
a2
B (30 mm)
a2
a1
Groove width measurement
INC origin
INC origin
Step measurement
Tips
For details about INC origin, "1.4.1 Origin Setup" (page 10)
1
Press to change to the INC origin setting.
»
[INC] will be displayed on the LCD screen.
2
Bring the probe into contact with surface a1 until a beep sound is made.
a1
a1
Step measurement Groove width measurement
»
[0.000] will be displayed on the LCD screen.
3
Bring the probe into contact with surface a2 until a beep sound is made.
Maintain contact between the probe and the surface a2.
Step measurement Groove width measurement
a2
»
When the measurement is complete, [H] and the measured value are displayed on the LCD screen.
To Next Page
Loading...
Need help?
General
