Mitutoyo QM-Height Series User's Manual / Instructions For Use

51
4 Troubleshooting
No. 99MAF029B
4
Troubleshooting
If a problem occurs while using this product, please try one of the solutions provided below. If the
solution does not work, contact our service department via your dealer for repair.
4.1
If the Following Problem Occurs
Based on the problem, determine the cause and the solution.
Problem Cause Solution
The power does not turn
on when
is pressed.
y
The batteries are not
inserted correctly.
y
Reinsert the batteries.
y
The AC adapter
(optional accessory) is
not properly connected.
y
Reconnect the AC adapter (optional
accessory).
The battery quickly
depletes.
The LED is set for
continuous use.
y
Change the setting of the LED lighting.
Tips
For details, "3.8 Setting the LED
Lighting Time" (page 46)
y
Remove the batteries if the product will not
be used for an extended period of time.
The air-float function does
not work (
is only lit
when the air-float switch
is pressed).
The batteries are too low
for the air-float function to
operate.
y
Replace all 4 batteries with new ones.
y
Connect an AC adapter (optional accessory).
Tips
• The air-float function uses an
excessive amount of electricity. If
you use this function often, using the
optional AC adapter is recommended.
• When using the air-float function, the
battery life (until the air-float no longer
functions) is around 1.5 hours.
Measurements are not
made even when the
probe comes in contact
with a workpiece (there is
no beep sound).
The clamp knob is locked. Loosen the clamp knob.
The displayed value
is being held, and the
workpiece cannot be
measured ([H] is displayed
on the LCD screen).
y
The displayed value is
held.
y
Press
to release the hold function.
y
The clamp knob is
locked.
y
Follow the instructions in "When the
displayed value is held, and the workpiece
cannot be measured" (page 52) to loosen
the clamp knob.
There is variance in the
measurements.
y
The probe clamp knob
is loosened.
y
Tighten the probe clamp knob.
y
The probe contacted
the workpiece with
excessive force.
y
Slowly bring the probe into contact with the
workpiece.

Mitutoyo QM-Height Series Specifications

General

Brand	Mitutoyo
Model	QM-Height Series
Category	Measuring Instruments
Language	English