26
2 Basic Measuring Methods
No. 99MAF029B
3
Move the probe left or right so that it
passes the center of the bottom surface
of the cylinder. Perform this action until a
beep sound is made.
»
The measurement of the
lowest point is complete, and
will be displayed on the
upper left of the LCD screen.
4
If you have tightened the clamp screw,
loosen it.
If the scanning measurement termination method is set to [ENTER] (manual termination)
1
Face the probe towards the center of the
bottom surface of the cylinder, and slowly
bring it into contact with the surface until
a beep sound is made.
Maintain contact between the probe and
the surface.
»
[0.000] will be displayed on the LCD
screen.
2
Secure the probe up/down wheel with
your hand or the clamp screw in order to
prevent it from moving.
3
Repeatedly move the probe left and
right.
»
The value displayed on the
LCD screen will change based
on the vertical movement of
the probe.
4
When the displayed value stops
changing, press .
»
The measurement of the
lowest point is complete, and
will be displayed on the
upper left of the LCD screen.
To Next Page
Loading...
Need help?
General
