34
3 Specific Usage Applications
No. 99MAF029B
2
With the measurement displayed, press and hold until a beep sound is made.
»
The surface plate is set as the origin.
Tips
• If you measured an inner or outer diameter in step 1, the median of that diameter will be set as the
origin point. If you made a plane scanning measurement, display the value that you want to set as
the origin point (median, minimum, maximum), and then press and hold .
• If you reversed the counting direction, follow the procedure in
"1.4.1 Origin Setup" (page 10)
to reset the origin.
• If following the procedure in
"1.4.1 Origin Setup" (page 10) to reset the origin, first press and
hold until a beep sound is made, and then perform the procedure.
• Removing the batteries or the AC adapter (optional accessory) cable will erase the origin setting.
2
Measure the inner diameter of s1.
»
The distance between the surface plate and a1 is displayed in the bottom row.
Tips
• For details about measuring inner diameters, "2.3 Measuring the Inner Diameter" (page 21)
• If inner diameter, outer diameter, or plane scanning measurements are made, the median
measurement will be set as the target value for determining distance.
3
Measure the inner diameter of s2.
»
The distance between the surface plate and a2 is displayed in the bottom row.
4
Press and hold until a beep sound is made.
»
The origin setting is canceled, and the product returns to normal measuring mode.
To Next Page
Loading...
Need help?
General
