17
2 Basic Measuring Methods
No. 99MAF600B
2
Basic Measuring Methods
Using the following workpiece as an example, the height, width, inner diameter, outer diameter, and
plane displacement measuring methods will be explained. Before measuring, make preparations such
as setting the reference.
Tips
For details about preparing measurements, "1.4 Preparing Measurements" (page 10)
2.1
Measuring the Height
There are 2 types of height measurement: one where the ball of the probe is brought into contact with
the top position of the workpiece for the top surface measurement, and one where the ball is brought
into contact with the lower position for the bottom surface measurement. As an example, the proce-
dure for measuring top surface height A (85 mm) and bottom surface height B (115 mm), shown be-
low, using the surface plate as the ABS reference is explained.
a1
A (85 mm)
a1
B (115 mm)
Bottom surface measurement
ABS reference ABS reference
Top surface measurement
Tips
For details about the ABS reference, "1.4.1 Reference Setup" (page 10)
1
Press and hold to change to the ABS reference setting.
» [ABS] will be displayed on the LCD screen.
To Next Page
Loading...
Need help?
General
