48
3SpecicUsageApplications
No. 99MAF600B
4 Press or to select the setting, and then press .
Setting Details
[out-d1] Outputs six digits of the measurement. If you will connect a device that
does not support eight-digit output, choose this setting.
[out-d2] Outputs eight digits of the measurement. If you will connect a device that
supports eight-digit output, choose this setting.
» Setup is complete.
• If the resolution for models that support inches is set to [0.00005 in], you can change which digits in the
measurement are output. By default, the lowest 6 digits are set to be output. For example, in [22.12345 in],
[2.12345 in] will be output. Use the following procedure to change the output to the highest 6 digits.
1 Press .
» Characters and icons will be displayed in the bottom row of the LCD screen.
2 Press to select [OUTPUT] (output setting).
3 Press or
until [888888] is displayed
.
4 Press or to select [88.8888] (the rst 6 digits), and then press .
» Setup is complete.
3.9.2 Outputting to a PC (Windows Only)
By connecting this product to your Windows PC using a micro USB cable, you can send measurement
results to the PC. Results can be output to commercially-available communication software.
Before sending the data, the communication driver must be installed on the PC. The system require-
ments for the communication driver are provided below.
Items Operating environment
OS Windows 10/Windows 8/Windows 7/Windows Vista
HDD capacity 500 KB or more
Display 800 x 600 resolution or higher, 256 colors or more
Other y Communication software is required.
y We recommend using the standard USB port on the main unit (the usage of
other USB ports are not ofcially supported).
y Internet access is required.
Tips
Sending can also be done using the optional USB input tool, U-WAVE, etc. For details, see the accompanying
manual for each product.
To Next Page
Loading...
Need help?
General
