Moeller DF6-340 Series - Page 178

01/02 AWB8230-1413GB
Standard form for user defined
parameter settings
175
C022 Signal to relay output K33-K34 (values a PNU C021) – 00 94
C026 Signal to relay terminals K11-K12
(values a PNU C021)
–05 93
C027 Output, FM output
• 00: Output frequency, PWM signal
• 01: Output current
• 03: Output frequency, FM signal
• 04: Output voltage
• 05: Inverter input power
• 07: Ramp frequency
–00 58
C028 Output, AM output
• 00: Output frequency, PWM signal
• 01: Output current
• 04: Output voltage
• 05: Inverter input power
• 06: Thermal load ratio
• 07: Ramp frequency
–00 57
C029 Output, AMI output (values a PNU C028) – 00 58
C031 Relay output K23-K24
• 00: Make contact
• 01: Break contact
–00 94
C032 Relay output K33-K34 (values a PNU C031) – 00 94
C036 Relay terminals K11K12, signalling relay
(values a PNU C031)
–01 93
C040 Overload alarm signal
• 00: Always
• 01: Only at constant speed
–01 97
C041 Threshold for overload alarm at digital relay output
K11 to K34
[A] I
e
97
C042 Frequency from which FA2 is switched on during
acceleration
[Hz] 0.00 95
C043 Frequency from which FA2 is switched off during
deceleration
[Hz] 0.00 95
C044 PID control deviation
(from the maximum setpoint value)
[%] 3.0 98
PNU Function Units WE Page Setpoint
efesotomasyon.com - Klockner Moeller - inverter