FlexStation 3 Benchtop Multi-Mode Microplate Reader User Guide
54 0112-0127 B
To install the fluidics module:
1. Grasp the handle on the fluidics module and use a second person
to help to lift the module into position over the detection
module.
2. Tilt module up at about 90° and have one person hold it in
position while the other person aligns the quarter-turn fasteners
in the flange to the holes in the bottom of the fluidics module.
3. Connect the quarter-turn fasteners to the bottom of the fluidics
module and lock the fasteners into place.
4. Attach the restraining cable from fluidics module to the right-
most mounting tab on the top cover of FlexStation 3 instrument.
The restraining cable comes attached to the fluidics module.
Figure 2-3: Restraining cable attached to the fluidics module
Attach the other end of the restraining cable the right-most
mounting tab on the top cover.
Figure 2-4: Restraining cable attached to the top cover
FlexStation_manual.book Page 54 Tuesday, June 25, 2013 10:22 AM
To Next Page
Loading...
Need help?
General