0112-0127 B 65
3
Operating Procedures
This chapter explains how to start up the system and how to use the
control panel and the SoftMax Pro Software to configure instrument
settings, define experiment protocols, and run an analysis, as described
in the following sections.
• Overview, see page 66
• Starting Up the System, see page 67
• Setting the Temperature, see page 72
• Setting Up the Software, see page 75
• SoftMax Pro Software Parameters, see page 78
• SoftMax Pro Software Parameters for Fluid Transfer, see page 86
• Other Software Settings, see page 99
• Reading a Microplate, see page 99
• Shutting Down the System, see page 103
• Optimizing Fluorescence Assays, see page 103
• Optimizing Time-Resolved Fluorescence Assays, see page 110
• Optimizing Fluorescence Polarization Assays, see page 111
• Optimizing Luminescence Assays, see page 112
Note: The information in this chapter assumes that the instrument and
computer are properly installed and connected. See
Installation on
page 49.
FlexStation_manual.book Page 65 Tuesday, June 25, 2013 10:22 AM
To Next Page
Loading...