© Copyright 2020 Moog, Inc.
3
1. PUMP COMPONENTS
Keypad
Press ON/OFF key for 1.5 seconds
to either turn Innity on or o.
Press and hold PRIME key to rapidly ll
disposable set with uid.
Release key to stop.
Press RUN/PAUSE key to either start
pump or place it in pause mode.
Press FEED INT key to display feed
interval setting.
Press VOL/TOTAL key once to display volume delivered for current
feeding. Press key again to display total cumulative volume
delivered in all feed cycles since total volume was last cleared.
Press RATE/DOSE key to transition between rate and dose settings.
Press CLEAR key to reset displayed function to its minimum value.
Press and hold for three seconds to clear rate, dose, feed interval
and volume delivered to minimum values at the same time.
Press + key to increase displayed feed function. Press
and hold key to increase value rapidly.
Press - key to decrease displayed feed function. Press
and hold key to decrease value rapidly.
Note: The following keys only function when pump
is in pause mode: PRIME, CLEAR, +, and - .
Figure 1-3 Keypad Layout
To Next Page
Loading...
