Moog Infinity User Manual

© Copyright 2020 Moog, Inc.
23
3. ALARMS, MESSAGES, AND INDICATIONS
NO FLOW IN (Figure 3-4)
Pump will sound a dual tone beep repeatedly
and display will read NO FLOW IN.
Why: This alarm has occurred because
pump has detected blockage in the
set between pump and bag.
To correct the problem: Press the RUN/
PAUSE key to silence alarm and place pump
in pause mode, then check the following:
1. Check tubing for kinks or formula
clumps. Correct blockage.
2. Check cassette receptacle for cleanliness,
especially around the pressure sensors.
If cleaning is necessary, refer to
CHAPTER 5 - CLEANING (Page 31).
NO FLOW OUT (Figure 3-5)
Pump will sound a dual tone beep repeatedly and display will read NO FLOW OUT.
Why: This alarm has occurred because
pump has detected a blockage in the
set between pump and patient.
To correct the problem: Press the RUN/
PAUSE key to silence alarm and place pump
in pause mode, then check the following:
1. Check tubing for kinks or blockages.
Remove kink or blockage.
2. Check cassette receptacle for cleanliness,
especially around pressure sensors.
If cleaning is necessary, refer to
CHAPTER 5 - CLEANING (Page 31).
3. Back pressure from patient may also cause
this alarm. Discuss with physician.
Figure 3-4 NO FLOW IN Alarm
Figure 3-5 NO FLOW
OUT Alarm

Moog Infinity Specifications

General

Model	Infinity
Type	Infusion Pump
Occlusion Pressure Settings	Low, Medium, High
Alarms	Occlusion, Low battery
Operating Temperature	10°C to 40°C
Storage Temperature	-20°C to 60°C
Manufacturer	Moog
Infusion Modes	Continuous, Intermittent
Display	LCD
Compatibility	Standard infusion sets