Moog Infinity User Manual

Innity
®
Enteral Feeding Pump Operator’s Manual
18
2. DIRECTIONS FOR USE
The Battery
Charging the Battery
To charge the battery, insert plug from AC
Adapter/Charger into port on the left side
of pump. Plug charger into a wall outlet.
Pump will charge whether it is
turned o or running.
When charger is plugged in and charging, the
plug symbol will appear in the display and the
fuel gauge will display four bars scrolling from
E to F. This pattern continuously repeats while
pump is charging (Figures 2-28a through 2-28e).
When bars stop scrolling pump is done charging.
To check the status of battery during
charging, disconnect charger from
pump and turn on pump.
NOTE: If pump shuts down due to low
battery, charging less than 10 minutes may
result in an ER99 alarm. Fully charge battery
if depleted (see page 22 to clear alarm).
a
b
c
d
e
Figure 2-28 Fuel Gauge

Moog Infinity Specifications

General

Model	Infinity
Type	Infusion Pump
Occlusion Pressure Settings	Low, Medium, High
Alarms	Occlusion, Low battery
Operating Temperature	10°C to 40°C
Storage Temperature	-20°C to 60°C
Manufacturer	Moog
Infusion Modes	Continuous, Intermittent
Display	LCD
Compatibility	Standard infusion sets