____________________________________________________________________
_______________________________________________________________________
MN0090-05 Page 6 of 68 18008
MPT-90 PRODUCT MANUAL This document contains U.S. export controlled technical data as regulated by the U.S. Export Administration Regulations 15 CFR Parts 730-774, export, disclosure or transfer contrary to U.S. law is prohibited.
1.0 INTRODUCTION
The purpose of this manual is to provide the MPT-90 Moog Pan and Tilt operator with
the required information necessary to install, operate, troubleshoot and maintain, the
MPT-90 to a level approved by the manufacturer, Moog Inc.
1.1 Scope
Read these instructions before installing or operating the MPT-90 Pan and Tilt.
This manual provides basic installation and operation information. In order to use this
document, the reader must have a basic knowledge of Windows-based PC computers
and adequate mechanical ability.
1.2 Customer support
If information beyond the scope of this manual is required, or you require assistance
with the setup, operation, maintenance, and troubleshooting of this product, refer to
this document. If you still have questions, please contact us at:
Moog, Inc.
Sensor and Surveillance Sales and Marketing
Northbrook, IL USA 60062
Telephone: 1-800-247-6563
(847) 498-0700
Email: moogs3service@moog.com
To help us better assist you we recommend that you are at the equipment and ready
with all available details including model & serial number before contacting Moog.
Refer to Figure 1.
Figure 1: Identification Label
The identification label is attached to the underside of the positioner.
Model Number
Serial Number
To Next Page
Loading...
Need help?
General