____________________________________________________________________
_______________________________________________________________________
MN0090-05 Page 64 of 68 18008
MPT-90 PRODUCT MANUAL This document contains U.S. export controlled technical data as regulated by the U.S. Export Administration Regulations 15 CFR Parts 730-774, export, disclosure or transfer contrary to U.S. law is prohibited.
7.0 MAINTENANCE & REPAIR
7.1 Routine Maintenance
Inspect the unit on a regular basis to assure the early detection and correction
of any minor problem before it becomes a major problem causing downtime.
The recommended inspection interval is dependent on the unit’s location,
severe weather conditions, or heavy use.
The following is a guideline to help establish a planned inspection program for
this equipment. The user of this equipment should make the final
determination on the inspection intervals.
7.1.1 Fresh Water Wash
The exterior of the Pan & Tilt Unit should be sprayed down every 6 months to
reduce damage due to salt spray and/or weather conditions.
7.1.2 Inspection Intervals
The following are the recommended inspection intervals for this equipment:
TYPE OF USE INSPECTION INTERVAL
Intermittent 6 months
Heavy User defined
Severe conditions User defined
7.1.3 Lubrication
INTERIOR INSPECTION (CONT)
Inspect the interior for foreign material/debris such as dust, dirt, or chips.
These items can act as an abrasive in the gear lubricant and reduce gear
life. Make sure to remove all foreign material. Clean the gears if necessary
and reapply gear lubricant.
Worm/Helical
Gear &
Lubrication
Visually inspect the gears for worn teeth, poor alignment, and chips. Clean
and lubricate the worms and worm gears every time the unit is opened (at
least every 6 months). AEROSHELL 64 is recommended.
Replace if missing or damaged. Cover O-Ring seals should be inspected
every 6 months and replaced if needed. Lubricate the O-Rings with O-Ring
lubricant prior to reattaching an access cover.
All bearings are sealed and lubricated for life.
Motors are lubricated for their design life and require no added lubricant.
Drive Chains (Pan & Tilt) should be lubricated with AEROSHELL 64.
THIS IS AN EXTREME PRESSURE LUBRICANT DO NOT
SUBSTITUTE. DO NOT MIX WITH ANY OTHER GREASE.
To Next Page
Loading...
Need help?
General