If your radio is set to Silent, it does not display any
audio or visual indicators during Emergency mode.
Press the programmed Emergency On button.
The display shows one of the following:
•
Tx Alarm and the destination alias.
•
Tx Telegram and the destination alias.
The LED lights up solid green and the Emergency
icon appears on the Home screen display.
The Emergency Search Tone sounds. It is
temporarily muted when the radio transmits or
receives voice. The tone stops when the radio
exits Emergency mode.
Note:
The Emergency Search Tone is an optional
feature, it can be enabled or disabled via
CPS. This feature is disabled, if Silent
Emergency is enabled. The CPS can also
program tone to sound to through the
speaker of the radio (default) or wired
accessory. Check with your dealer or
system administrator to determine how
your radio has been programmed.
When an Emergency Alarm acknowledgement is
received, the Emergency tone sounds and the
LED blinks green. The display shows Alarm Sent.
If your radio does not receive an Emergency
Alarm acknowledgement, and after all retries have
been exhausted, a tone sounds and the display
shows Alarm Failed.
Radio exits the Emergency Alarm mode and
returns to the Home screen.
Sending an Emergency Alarm with Call
This feature allows you to send an Emergency Alarm
to a group of radios. Upon acknowledgement by a
radio within the group, the group of radios can
communicate over a programmed Emergency
channel.
If your radio is set to Silent, it does not display any
audio or visual indicators during Emergency mode, or
allow any received calls to sound through the speaker
of the radio, until you press the PTT button to initiate
the call.
If your radio is set to Silent with Voice, it does not
display any audio or visual indicators during
Emergency mode, but allow incoming calls to sound
62
English
To Next Page
Loading...