The display shows one of the following:
•
Tx Alarm and the destination alias.
•
Tx Telegram and the destination alias.
The LED lights up solid green and the Emergency
icon is displayed.
The Emergency Search Tone sounds. It is
temporarily muted when the radio transmits or
receives voice. The tone stops when the radio
exits Emergency mode.
Note:
The Emergency Search Tone is an optional
feature, it can be enabled or disabled via
CPS. This feature is disabled, if Silent
Emergency is enabled. The CPS can also
program tone to sound to through the
speaker of the radio (default) or wired
accessory. Check with your dealer or
system administrator to determine how
your radio has been programmed.
2
Once the display shows Alarm Sent, speak
clearly into the microphone.
When hot mic has been enabled, the radio
automatically transmits without a PTT button press
until the hot mic duration expires. While
transmitting, the LED lights up solid green and the
Emergency icon appears on the display.
3 The radio automatically stops transmitting when
the cycling duration between hot mic and receiving
calls expires, if Emergency Cycle Mode is
enabled.
4 Once the hot mic duration expires, the radio
automatically stops transmitting. The LED blinks
red and the radio remains in Emergency mode. To
transmit again, press the PTT button.
Reinitiating an Emergency Mode
Note:
This feature is only applicable to the radio
sending the Emergency Alarm.
There are two instances where this can happen:
• You change the channel while the radio is in
Emergency mode. This exits the Emergency
mode. If Emergency Alarm is enabled on this new
channel, the radio reinitiates Emergency.
• You press the programmed Emergency On
button during an Emergency initiation/transmission
65
English
To Next Page
Loading...