4 - 32 DS4208 Digital Scanner Product Reference Guide
Multicode Concatenation Symbology
Parameter # F1h D2h
Use this parameter to specify how to transmit the concatenated bar codes decoded as specified by the Multicode
Expression. Multicode Mode Concatenation must be enabled to use this option.
Multicode Troubleshooting
Troubleshooting Multicode Expression Programming
Use the following suggestions if encountering problems programming a multicode expression:
•
Ensure the expression is valid. Invalid expressions are rejected during programming. When an expression is
rejected the previous expression remains intact. If after programming the expression the digital scanner can
still decode any bar code, the expression was possibly rejected.
•
When programming the multicode expression via parameter bar code, the digital scanner generates beeps. If
any of the following beeps do not sound during programming, an error occurred (see Table 2-1 on page 2-2
and Table 2-2 on page 2-4 for error indicators):
• Scanning the
Multicode Expression bar code produces a two-tone (same pitch) beep.
• Scanning each value of the expression produces a two-tone (same pitch) beep.
• Scanning the
End Of Message bar code produces a four-tone (high-low-high-low) beep.
•
Check the expression for syntax errors.
Concatenation as Code 128
(01h)
* Concatenation as PDF417
(02h)
Concatenation as Data Matrix
(03h)
Concatenation as Maxicode
(04h)
To Next Page
Loading...
Need help?
General
