Motorola DS4208 Product Reference Guide

Appendix A Standard Default Parameters
Table A-1 Standard Default Parameters Table
Parameter
Parameter
Number
Default
Page
Number
User Preferences
Set Default Parameter Set Defaults 4-4
Parameter Bar Code Scanning ECh Enable 4-5
Beep After Good Decode 38h Enable 4-5
Beeper Tone 91h Medium 4-6
Beeper Volume 8Ch High 4-7
Beeper Duration F1h 74h Medium 4-7
Suppress Power-up Beeps F1h D1h Do not suppress 4-8
Low Power Mode 80h Disable 4-8
Time Delay to Low Power Mode 92h 1 Hour 4-9
Hand-Held Trigger Mode 8Ah Auto Aim 4-11
Picklist Mode F0h 92h Always Disabled 4-12
Continuous Bar Code Read F1h 89h Disable 4-13
Unique Bar Code Reporting F1h D31h Disable 4-13
Decode Session Timeout 88h 9.9 Sec 4-14
Timeout Between Decodes, Same Symbol 89h 0.5 Sec 4-14
Timeout Between Decodes, Different Symbols 90h 0.2 Sec 4-15
Fuzzy 1D Processing F1h 02h Enable 4-15
1
User selection is required to configure this interface and this is the most common selection.

Motorola DS4208 Specifications

General

Connectivity	Wired
Sealing	IP43
Voltage	5 VDC ± 10%
Scan Pattern	Omnidirectional
Interface	USB, RS232, Keyboard Wedge
Decode Capability	1D
Drop Specification	Withstands multiple 6 ft. (1.8 m) drops to concrete
Operating Temperature	32° to 104° F (0° to 40° C)
Storage Temperature	-40°F to 158°F (-40°C to 70°C)
Humidity	5% to 95% (non-condensing)
Lighting	Tolerant to typical artificial indoor and natural outdoor (direct sunlight) lighting conditions
Power Consumption	2.5 W (typical)
Current	500 mA
Cable Length	6 ft (1.8 m)