244
Signalling Muting Type Use the UP/DOWN arrow keys to scroll through the available
selections. This field dictates the Signalling Muting Type to be used
during Quik-Call II operations:
The default is AND.
Initial Squelch Type This is a view-only field which will be visible only if the Signalling Muting
Type field is set to AND.
Reset Type Use the UP/DOWN arrow keys to scroll through the available
selections. This field dictates the Quik-Call II Call Reset Type to be
used: Manual or Auto. When Manual Reset is selected, a Monitor
button is required for proper Quik-Call II operation.
The default is Auto.
Auto Reset Carr Ovrd Use the UP/DOWN arrow keys to scroll through the available
selections. When this feature is enabled, the Auto Reset Duration will
be re-loaded into the Auto Reset Timer when the radio mutes.
The default is Enabled.
Auto Reset Duration (sec) Use the UP/DOWN arrow keys to scroll or directly enter the desired
value. This field determines the maximum amount of uninterrupted
time spent in Release Squelch Mode. When this duration expires, the
radio will exit Release Squelch Mode and enter Quik-Call II Squelch
Mode. Integer values from 1 to 255 are allowed.
The default is 5.
Decoder 1 Call Type Use the UP/DOWN arrow keys to scroll through the available
selections. This field dictates the Decoder 1 Call Type: Individual or
Group.
Note: When Group is selected, a steady beep will be heard when
a call is decoded. When Individual is selected, an intermittant
beep will be heard when a call is decoded.
The default is Individual.
Decoder 2 Call Type Use the UP/DOWN arrow keys to scroll through the available
selections. This field dictates the Decoder 2 Call Type: Individual or
Group.
Note: When Group is selected, a steady beep will be heard when
a call is decoded. When Individual is selected, an intermittant
beep will be heard when a call is decoded.
The default is Group.
AND Both Signalling Unmuting (Quik-Call) and Radio Unmuting
must be satisfied for the radio to unmute.
OR Either Signalling Unmuting (Quik-Call) or Radio Unmuting
must be satisfied for the radio to unmute.
To Next Page
Loading...
Need help?
General