245
Decoder Option Use the UP/DOWN arrow keys to scroll through the available
selections. This field controls the number of decoders (1 or 2) and the
decode sequences to be used on this Quik-Call II system. The available
selections are:
(1) A-B
(1) A-B, (2) A-C
(1) A-B, (2) C-B
(1) A-B, (2) B
(1) A-B, (2) C
(1) A-B, (2) C-D
The default is (1) A-B.
Long Tone Duration This field will be visible only if the Decoder Option field is set to (1) A-B, (2)
C or (1) A-B, (2) B. Use the UP/DOWN arrow keys to scroll or directly
enter the desired value. This is the duration that a tone has to last in
order for it to be considered a valid long tone. This value may range
from 4 to 10 seconds in 100-ms increments.
The default is 4.
Frequency (Hz) Use the UP/DOWN arrow keys to scroll or directly enter the available
tones. This field represents the frequency of the audible tone in 0.1-Hz
increments. Values ranging from 288.5 to 3010.0 in 0.1 Hz increments
are valid.
Code Use the UP/DOWN arrow keys to scroll or directly enter the desired
code. This field contains a code that represents a Quik-Call II Tone
frequency. Codes vary depending on the type of Signalling system selected.
To Next Page
Loading...
Need help?
General