• Back: SENSOR5
• OK: SENSOR3
8 Execute command CPPROG_CAP_TOUCH to write the buffer value into the codeplug.
Radio firmware returns CP_OK indicating the new value has been written into the codeplug.
9 Execute command CAP_TOUCH WRITE USER_CONFIGURATION_REGISTERS to reset the
captouch chipset and initialize with the new threshold value.
10 To verify the sensitivity of the configured threshold, perform functional test on the captouch
buttons. Repeat step 1 to step 9 if the touch sensitivity is not satisfactory.
MN002952A01-AH
Chapter 4: Test Setup and Testing
63
To Next Page
Loading...
