95
Field Definitions
Plug-In Board Use the UP/DOWN arrow keys to make your selection. Set this field to
“Installed” if an audio-processing option board is installed in the
radio. The audio routing path for both Transmit and Receive audio will
be modified such that this audio can be processed by the board prior
to transmission or reception of the signals.
Note: DO NOT set the Plug-In Board field to “Installed”
unless an option board has actually been installed. If you do
so, the radio will remain muted and no audio will be
transmitted.
The default is “Not Installed”.
Special Cloning
Instructions
Radio-to-Radio Cloning It will NOT be possible to clone HT 1000 “C” or later models radios through
the direct radio-to-radio cloning process unless their Option•Mate Plug-In
Board fields are set to the same value (that is, either “Installed” or “Not
Installed”).
This is to make sure that audio routing information from an
Option•Mate-enabled radio is not cloned to a non-capable (earlier
model) radio since this will render the earlier radio inoperative. For
example, if an HT 1000 “C” model is cloned radio-to-radio to an
HT 1000 “B” or earlier model, the Plug-In Board field in the “C” model
must be set to “Not Installed”. Otherwise, cloning will NOT be allowed.
Radio-to-radio cloning where an HT 1000 “A” model is the source
radio is an exception. If an HT 1000 “A” model is cloned radio-to-radio to
an HT 1000 “C” model which has an Option•Mate Plug-In Board field set
to Installed, the audio routing information WILL BE LOST and must be
reprogrammed.
RSS Cloning RSS Cloning will however be allowed even if the Option•Mate settings
are different. The setting in the source radio will be copied on to the
target radio and a warning will be issued.
Note: For further tips on RSS cloning, refer to screen HELP for
the GET/SAVE/CLONE screen (F3) and to the “Clone Radio”
section in Section 3 of this manual.
To Next Page
Loading...
