9
Anatomy of a Menu Within the RSS, there are menus that will take you to other menus
and/or to screens where you can change the choice or value of a field.
The only difference between a menu and a screen is the information
which appears in the working area, marked by the letter C in the figure
below. A menu or screen has four areas, labelled below as A, B, C and D.
RSS Location ID Area In this area you will find the words “MOTOROLA Radio Service
Software”, the product name (HT/JT1000/VISAR), the radio’s model
number and a menu or screen path name for the current menu or
screen shown on the display.
Instruction Message Area As the name indicates, this area suggests specific actions such as
“Select a function key, F1-F10”, “Use UP/DOWN arrows to scroll
value,” and so on. This area also contains status messages that indicate
the progress of non-interactive functions such as codeplug reading,
and provide the range of acceptable values for the current data entry
field.
Working Area This area of a menu (not a screen) displays a list of functions (menu
choices) that you can execute from the current menu. Each menu item
is preceded by an F-key (function key). Pressing an F-key from among
the available choices advances you to another menu or screen as the
case may be.
F-Key (Function Key) ID
Area
This area displays the valid F-keys and their corresponding function
names for the current menu or screen.
Note: All functions (supported and unsupported) will be
displayed in the menu’s working area. The unsupported
functions (based on the radio’s model or options) will, however,
NOT be displayed in the F-key area.
MOTOROLA Radio Service Software Select a function key, F1-F10.
HT/JT1000/VISAR Model :
Serial:
Main Menu
---------
F1 - HELP
F2 - Service: Alignment (Requires RIB)
F3 - Get/Save/Clone/Program Codeplug Data From/to Disk/Radio
F4 - Change/View Radio Codeplug Data
F5 - Print Codeplug Values
F6 -
F7 -
F8 -
F9 - Set Up Computer Configuration
F10 - EXIT Radio Service Software, Return to DOS
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10
HELP SERVICE GET/ CHANGE PRINT SET UP EXIT
SAVE /VIEW TO DOS
A
B
C
D
A
B
C
D
To Next Page
Loading...
