132
DTMF Configuration
(HT 1000 “B” or Later
and JT1000 Models
only)
From the MAIN MENU, press F4, F3, F7, F5 and then F2 to access this
screen.
This screen will be accessible only for HT 1000 “B” and JT1000 models.
From this screen, you can configure additional DTMF options.
Function Key Descriptions
F5 - PRINT Prints the current system configuration.
F9 - DEFAULT Resets the fields on this screen to their default values.
Field Definitions
Access/De-Access Type Use the UP/DOWN arrow keys to make your selection. This field is
used to specify whether the radio’s Telephone Interconnect access is
automatic or manual. If set to Automatic, the radio will automatically
send the pre-programmed access code when the radio’s Phone button
is pressed, and will automatically send the pre-programmed de-access
code when the Phone button is pressed to hang up. If set to Manual,
the access/de-access codes must be keyed in manually.
DTMF Tone Type Use the UP/DOWN arrow keys to make your selection. The setting in
this field determines whether the DTMF tones transmitted are
Continuous or Timed in a manual dial situation.
DCGEB
MOTOROLA Radio Service Software Use <: keys to enable/disable feature
HT/JT1000/VISAR Model : H01KDC9AA1DN Use <Enter> to go to next feature.
Serial:
CHANGE:RADIO:SIG:DTMF:CONFIG
Õ
DTMF CONFIGURATION
------------------
Access/De-Access Type.........Automatic DTMF Pre-Emphasis........Enabled
DTMF Tone Type...............Continuous DTMF Sidetone Type.....DTMF Tone
User Phone List Programming.....Enabled
DTMF ANI Type......................None
DTMF ANI Code..................12345678
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10
HELP PRINT DEFAULT EXIT
Continuous Transmitted as long as the key is held down.
Timed Transmitted for the length of time specified by the DTMF
Digit Duration field on the DTMF PHONE LIST screen
(F4/F3/F7/F5).
To Next Page
Loading...
