134
Scan List From the MAIN MENU, press F4, F3 and then F8 to access this screen.
You can specify scan list entries from this screen.
Function Key Descriptions
F2 - SCAN CONFIG
(Scan Configuration)
Brings up a screen where you can configure the radio’s scan function.
F5 - PRINT Prints the current system configuration.
Field Definitions
Scan List Entries Use the UP/DOWN arrow keys to determine whether a channel is
included (enabled) or excluded (disabled), from the scan list.
The default is Disabled.
Note: Only the number of channels appropriate for the particular
model will be displayed. If a channel is marked as
“Unprogrammed” in the CHANNEL CONFIGURATION screen
(F4/F4), it will be removed from the Scan List when you exit this
screen. Be sure to set channels to “Programmed = Yes” before
adding them to the scan list.
DCH
MOTOROLA Radio Service Software Use <: keys to enable/disable feature.
HT/JT1000/VISAR Model : Use <Enter> to go to next feature.
Serial:
CHANGE:RADIO:SCAN LIST
Scan List
---------
1............Disabled 9............Disabled
2............Disabled 10...........Disabled
3............Disabled 11...........Disabled
4............Disabled 12...........Disabled
5............Disabled 13...........Disabled
6............Disabled 14...........Disabled
7............Disabled 15...........Disabled
8............Disabled 16...........Disabled
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10
HELP SCAN PRINT EXIT
CONFIG
To Next Page
Loading...
