Motorola VISAR - Main Menu

15
Main Menu Press any key at the BANNER screen to access the MAIN MENU.
The MAIN MENU is the starting point of the RSS. All the major
programming functions that you can perform using the RSS are listed
in the center box or working area of this screen. You can make your
selection by pressing the appropriate function key (labeled F1 through
F10 on the keyboard). You can return to the MAIN MENU at any time
from other RSS menus or screens by pressing the Esc key.
You must first load data from a radio (or disk) using the GET/SAVE function
(F3) before being you will be allowed to access the CHANGE/VIEW (F4) and
related screens. Refer to for information on how to retrieve codeplug
data.
Note: If you make changes to the codeplug but did not save
them and try to exit the RSS, a warning message will be
displayed. You will be prompted to press F2 to exit to DOS, or to
press F10 to continue.
MOTOROLA Radio Service Software Select a function key, F1-F10.
HT/JT1000/VISAR Model :
Serial:
Main Menu
---------
F1 - HELP
F2 - Service: Alignment (Requires RIB)
F3 - Get/Save/Clone/Program Codeplug Data From/to Disk/Radio
F4 - Change/View Radio Codeplug Data
F5 - Print Codeplug Values
F6 -
F7 -
F8 -
F9 - Set Up Computer Configuration
F10 - EXIT Radio Service Software, Return to DOS
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10
HELP SERVICE GET/ CHANGE PRINT SET UP EXIT
SAVE /VIEW TO DOS