97
The combination which is highlighted when the screen is entered for
the first time is the one that is currently programmed into the radio. If
you made any changes, the combination which is highlighted when
the screen is exited is the one which will be programmed into the
radio.
A combination marked “Blank” is available if it is desired to make the
switch non-functional. A combination marked “Unsupported Switch”
is also available so that any switch setup not exactly matching one of
the choices provided will be preserved. This selection cannot be
accessed through keyboard navigation.
Note: The RSS will NOT allow a toggle switch setup that duplicates
functions already assigned to other controls. Here is an example:
assume that Scan has been assigned to the Toggle Switch and
Channel Slaved Auto Scan has been programmed in the same
radio. If Scan is already assigned to another control, it will not
be possible to navigate to Scan-related selections on this screen.
Conflicts may occur if a Toggle Switch setup is chosen that controls
power, and one or more channels are programmed for low power. The
radio will always prioritize the Toggle Switch input over the
channel-slaved input. Therefore it is possible that a radio
COULD transmit at high power on a channel which has been
configured for low power. Please exercise caution in using
multiple controls to manipulate power.
The RSS will NOT allow High/Low Power or High/Low Power/Scan
for JT1000 models. High/Low Power is front-panel
programmable. 800 MHz models are always High Power.
Refer to the following page for a list of available modes and the
functions associated with them.
To Next Page
Loading...
