124
Singletone TX Pretime Enter a value directly or use the UP/DOWN arrow keys to make your
selection. This is the time period preceding the transmission of the
Single Tone during which silent carrier or carrier with PL (if on a PL
channel) is transmitted. This time can range from 0 (zero) to 6375 ms
in 25-ms increments.
The default is 250.
Singletone Sidetone This sidetone applies to Single Tone encode via PTT only. Use the UP/
DOWN arrow keys to enable/disable the sidetone feedback during
Single Tone encode. The sidetone is a 900 Hz tone which lasts for the
duration of the transmitted Single Tone.
The default is Enabled.
Side button accept tone Use the UP/DOWN arrow keys to enable/disable the Accept Tone that
is generated as feedback to the user when a Single Tone is encoded via
a side button. The accept tone is a 900 Hz, 75 ms tone.
The default is Disabled.
Note: In order for Single Tones to operate properly, they must be
enabled for each channel on the CHANNEL CONFIGURATION
screen (F4/F4/F2). If Single Tone on a side button is desired, the side
button must be assigned on the SIDE BUTTON CONFIGURATION
screen (F4/F3/F3).
To Next Page
Loading...
