25
Function Key
Descriptions
F2 - REF FREQ
(Reference Frequency
Alignment)
This screen reads the radio codeplug, and then allows you to align the
reference oscillator softpot. Refer to the appropriate Radio Service
Manual for details of this procedure. This procedure should only be
attempted by qualified service personnel.
F3 - TRANSMIT POWER
(Transmit Power Alignment)
This function is used to align the radio’s transmit power. Refer to the
appropriate Radio Service Manual for the Transmitter Power
Alignment procedure. This procedure should only be attempted by
qualified service personnel.
F4 - DEV BAL
(Transmit Deviation Balance
[Compensation] Alignment)
This function is used to balance the radio’s transmit deviation. Refer
to your Radio Service Manual for the Transmit Deviation Balance
(Compensation) Alignment procedure. This procedure should only be
attempted by qualified service personnel.
F5 - DEV LIMIT
(Transmit Deviation Limit
Alignment)
This function is used to perform transmit deviation limit alignment.
Refer to your Radio Service Manual for the Transmit Deviation Limit
Alignment procedure. This procedure should only be attempted by
qualified service personnel.
F6 - DEV REF
(Transmit Deviation Limit
Alignment: Reference Softpot)
This function is used to perform the transmit deviation limit
alignment: reference softpot procedure. Refer to your Radio Service
Manual for the Transmit Deviation Limit Alignment Reference Softpot
procedure. This procedure should only be attempted by qualified service
personnel.
F7 - VCO XOVER
(Transmit VCO Crossover
Alignment)
This function is used to perform transmit VCO crossover alignment.
Refer to your Radio Service Manual for the Transmit VCO Crossover
Alignment procedure. This procedure should only be attempted by
qualified service personnel.
To Next Page
Loading...
