Motorola VISAR - Page 82

76
Flashing LED Use the UP/DOWN arrow keys to set the field to Disabled, Channel
Busy, Low Battery, or Chan-Busy/Low-Batt.
The default is Chan-Busy/Low-Batt.
Quick Key Override Use the UP/DOWN arrow keys to enable/disable PTT Quick Key
Override mode. If this feature is enabled and two PTT activations occur
within one second of each other, this feature will override the transmit
inhibit option and allow the radio to transmit over the “Channel
Busy” condition.
The default is Enabled.
Tx Inhibit Monitor Function Use the UP/DOWN arrow keys to enable/disable the normal
monitoring of channels when Transmit Inhibit On Busy Channel is
enabled.
The default is Enabled.
Battery-Saver PL Lockout Use the UP/DOWN arrow keys to enable/disable this feature. If this
feature is enabled, PL will not be decoded when the radio periodically
comes out of sleep mode until carrier drops. Therefore, a radio which
enters sleep mode while a carrier is on the channel with wrong PL or
no PL will not unmute to another call until carrier drops.
Note: This method of operation (not decoding PL) significantly
increases battery savings, but can cause problems in some
systems. Use of Battery Saver should be carefully tested in the
customer system when the option is enabled.
The default is Disabled.
Low Battery The LED will blink when the battery voltage falls below a
predetermined value.
Channel Busy The LED will blink when a carrier is present on a receive-
PL channel.