86
Monitor Long Press Period (sec) Enter a value directly or use the UP/DOWN arrow keys to select the
length of time that the Monitor Button must be held down to engage
Permanent Monitor mode. The valid range of values is 1 to 16 seconds.
The default is 5 seconds.
Scan
Programming
Status Scroll
Allows the operator to select a channel's status in the
scan list by scrolling through three states (Not in List,
Non-Priority, Priority) as this button is pressed. The
status of the channel is indicated by the bi-color LED.
LED OFF indicates “Not in Scan List,” LED Green
indicates “Non-Priority Status” and LED Red indicates
“Priority Status”.
Monitor/Scan
Programming
Status Scroll
Combines the Monitor function with Scan
Programming Status Scroll while in Scan Programming
mode.
Emergency
Alarm
An MDC or STAR Emergency Alarm sequence is
initiated when this button is pressed.
Phone Encode Places the radio in Telephone Encode mode, initiating
an auto-access sequence if so programmed. Applicable to
keypad models only.
Select Allows temporary removal of a channel from the scan
list in the Nuisance Delete Function, and performs the
Scan Programming Status Scroll function in Scan
Programming mode.
Scan/Scan
Programming
On/Off
A short press will toggle the Channel Scan mode on
and off. A long press will place the radio in the Scan
Programming mode where the scan list can be modified
by the radio operator.
Note: In Scan Programming mode, the radio will not
unmute to channel traffic. A tone will sound to remind
the operator if the radio was left in Scan Programming
mode with no key activity for more than 20 seconds. To
complete the Operator Selectable scan functionality,
the other side button must be assigned to the Scan
Programming Status Scroll function. Refer to page 87 for
scan-related button setups.
Single Tone #1
and #2 Encode
Initiates transmission of the selected Single Tone.
Scan On/Off Allows scan to be toggled on and off. No scan
programming is allowed with this setup.
Light Button Allows the radio user to toggle the display/keypad
backlighting on and off on keypad-equipped radios only.
To Next Page
Loading...
