Moxa Managed Ethernet Switch (UI_2.0_FW_5.x) User Manual
Network
Network conf iguration allows users to conf igure both IPv4 and IPv6 parameters f or management access
over the network. The Moxa switch supports both IPv4 and IPv6, and can be managed through either of
these address types.
IP Settings
The IPv4 settings include the switch’s IP address and subnet mask, as well as the IP address of the default
gateway. In addition, input cells are provided f or the IP addresses of a 1st and 2nd DNS server.
The IPv6 settings include two distinct address types—Link-Local Unicast addresses and Global Unicast
addresses. A Link-Local address makes the switch accessible over IPv6 for all devices attached to the same
local subnet. To connect to a larger network with multiple segments, the switch must be conf igured with a
Global Unicast address.
Get IP From
DHCP
The Moxa switch’s IP address will be assigned automatically by
the network’s DHCP server.
Manual
BOOTP
The Moxa switch’s IP address will be assigned automatically by
the network’s BootP server.
The Moxa switch’s IP address must be set manually.
IP Address
switch
Assigns the Moxa switch’s IP address on a TCP/IP network. 192.168.127.253
Subnet Mask
Subnet mask for the
Moxa switch
Identif ies the type of network the Moxa switch is connected to
(e.g., 255.255.0.0 f or a Class B network, or
a Class C network).
24(255.255.255.0)
Default Gateway
IP address for gateway
Specifies the IP address of the router that connects the LAN to
an outside network.
None
To Next Page
Loading...
Need help?
General
