Moxa Managed Ethernet Switch (UI_2.0_FW_5.x) User Manual
The information shown in the table includes:
• Dynamic Router Port: Indicates that a multicast router connects to or sends packets from these port(s).
• Static Router Port: Displays the static multicast querier port(s).
• Querier Connected Port: Displays the port that is connected to the querier.
• Role: Indicates if the switch is a querier. Displays Querier or Non-Querier.
• Group: Displays the multicast group addresses.
• Port: Displays the port that receives the multicast stream or the port the multicast stream is f orwarded
to.
• Version: Displays the IGMP Snooping version.
• Filter Mode: Indicates that the multicast source address is included or excluded. Displays Include or
Exclude when IGMP v3 is enabled.
• Sources: Displays the multicast source address when IGMP v3 is enabled.
Stream Table
This page displays the multicast stream f orwarding status. It allows you to view the status by VLAN ID.
Stream Group: Multicast group IP address
Stream Source: Multicast source IP address
Port: The port that receives the multicast stream
Member Ports: Ports the multicast stream is forwarded to
NOTE
IGMP Stream Status is only supported by Moxa’s Layer 3 switches.
To Next Page
Loading...
