Dot1X Radius Server Setting
Same as Auth Server Setting
Setting Description Factory Default
Enable/Disable Enable to use the same setting as Auth Server Disable
Server Setting
Setting Description Factory Default
Server IP/Name Specifies the IP/name of the server localhost
Server Port Specifies the port of the server 1812
Server Shared Key Specifies the shared key of the server None
Port Access Control Table
The port status will show authorized or unauthorized.
Using Auto Warning
Since industrial Ethernet devices are often located at the endpoints of a system, these devices will not always
know what is happening elsewhere on the network. This means that an industrial Ethernet switch that connects
to these devices must provide system maintainers with real-time alarm messages. Even when control
engineers are out of the control room for an extended period of time, they can still be informed of the status of
devices almost instantaneously when exceptions occur. The Moxa switch supports different approaches to warn
engineers automatically, such as email and relay output. It also supports two digital inputs to integrate sensors
into your system to automate alarms by email and relay output.
Configuring Email Warning
The Auto Email Warning function uses e-mail to alert the user when certain user-configured events take place.
Three basic steps are required to set up the Auto Warning function:
To Next Page
Loading...
Need help?
General
