Moxa Technologies Managed Ethernet Switch/Extender - Configuring Virtual LAN

Moxa Managed Ethernet Switch/Extender Featured Functions
3-45
Configuring Virtual LAN
VLAN Settings
To configure 802.1Q VLAN and port-based VLANs on the Moxa switch, use the VLAN Settings page to
configure the ports.
VLAN Mode
Setting Description Factory Default
802.1Q VLAN Set VLAN mode to 802.1Q VLAN 802.1Q VLAN
Port-based VLAN Set VLAN mode to Port-based VLAN
Unaware VLAN
Set VLAN mode to Unaware VLAN
NOTE
Only
EDS-728 and IKS-6726/6728 provides the Unaware VLAN function.
802.1Q VLAN Settings
Management VLAN ID
Setting Description Factory Default
VLAN ID from 1 to 4094
Assigns the VLAN ID of this Moxa switch. 1
Port Type
Setting Description Factory Default
Access
Port type is used to connect single devices without tags.
Access
Trunk Select Trunk port type to connect
another 802.1Q VLAN aware
switch
Hybrid Select Hybrid port to connect another Access 802.1Q VLAN
aware switch or another LAN that combines tagged and/or
untagged devices and/or other switches/hubs.
ATTENTION
For communication redundancy in the VLAN environment, set
Redundant Port Coupling Port and
Coupling Control Port
as Trunk Port since these ports act as the backbone to transmit all packets of
different VLANs to different Moxa switch units.