Moxa Technologies Managed Ethernet Switch/Extender - Using HTTPS;SSL

Moxa Managed Ethernet Switch/Extender Featured Functions
3-84
Syslog Server 1/2/3
Setting Description Factory Default
IP Address Enter the IP address of Syslog server 1/2/3, used by your
network.
None
Port Destination
(1 to 65535)
Enter the UDP port of Syslog server 1/2/3. 514
NOTE
The following events will be recorded into the Moxa switch’s Event Log table, and will then be
sent to the
specified Syslog Server:
•
Cold start
•
Warm start
•
Configuration change activated
•
Power 1/2 transition (Off (On), Power 1/2 transition (On (Off))
•
Authentication fail
•
Topology changed
•
Master setting is mismatched
•
Port traffic overload
•
dot1x Auth Fail
•
Port link off/on
Using HTTPS/SSL
To secure your HTTP access, the Moxa switch supports HTTPS/SSL to encrypt all HTTP traffic. Perform the
following steps to access the Moxa switch’s web browser interface via HTTPS/SSL.
1. Open Internet Explorer and type https://{Moxa switch’s IP address} in the address field. Press Enter
to establish the connection.
2. Warning messages will pop up to warn the user that the security certificate was issued by a company they
have not chosen to trust.