LinkCom 5 User Manual
Page 11
Provides bi-directional communication between host and selected printer.
(TCP/IP printing. Not USB)
TCP/IP. ver.6 and ver.4 supported.
(Provided that the host/printer also supports IPv6)
Link speed
Gigabit support on the LAN port. 10/100MB support on both LAN and PRT
ports.
3.3 Requirements
This section describes the hardware and host requirements needed for operating
LinkCom 5.
For specification on MPI Tech host-operating system requirements and installation,
please see:
PSS MVS, Product Installation Guide, doc. no. D13052
PSS VM, Installation Guide, doc. no. D13055
EPM MVS Product Guide, document no. D13070
3.3.1 PC system requirements
Hardware:
PC/Server with LAN adapter able to run Windows with the software mentioned
below.
Software:
PrintGuide version S42 065.490 or newer. This version of PrintGuide supports the
LinkCom 5 product, and is used for configuring the product.
3.3.2 Printer requirements
A printer that is connected to LinkCom 5 via a USB cable must be self-powered. It
may not require power via the USB plug exceeding 100mA.
3.3.3 Host system requirements
Mainframe MVS
IBM PSF version 2.1 or higher
PSS/MVS
Either PSS version 6.01 or higher or EPM
ACF/VTAM version 3.1 or higher is required
IBM TCP/IP version 2.1 or higher or Interlink TCP/Access ver.3.1 or higher
Mainframe VM
IBM PSF version 2.1 or higher (only VTAM connection)
To Next Page
Loading...