LinkCom 5 User Manual
Page 56
8 Configuration of host systems
The host system must be setup to allow printing via the LinkCom 5 PrintServer. The
actual setup depends on the host system. If in doubt, please consult the host
system manual. Please note that the host system sees the LinkCom 5 PrintServer
as a printer.
8.1 Setup in mainframe TCP/IP environment
The descriptions in the sections below relate to the different print options from IBM
Mainframe / System z-series.
8.2 PSF/MVS AFP/IPDS printing
This section provides you with the PSF Start-up Procedures
Once these parameters have been configured, and the basic installation of the
LinkCom 5 PrintServer has been completed, direct AFP / IPDS from PSF / MVS is
possible.
Requirements:
PSF/MVS version 2.2.0 with PTF level UW21345 or higher
TCP/IP ver. 2, Rel. 1 or higher
Interlink TCP/Access Ver.3.1 or higher
8.2.1 PSF/MVS start-up procedure
Using IP address 192.0.110.21 and port number 5001.
The IP address of the LinkCom 5 PrintServer should be programmed in the IP-
address (IPADDR=‘192.0.110.21’). The port number (PORTNO=5001) is the default
port number of the IPDS port in print server.
8.3 PSS/MVS AFP/ICDS printing
This section provides:
000001 //PSF4 PROC
000002 //STEP01 EXEC PGM=APSPPIEP,REGION=1750K
.
.
.
000034 //******************************************************************
000035 //* STANDARD PRINTDEV */
000036 //*****************************************************************
000037 //PRT420 CNTL
000038 //PRT420 PRINTDEV FONTDD=*.FONT01, /* FONT LIBRARY DD */
.
.
.
000058 // IPADDR=‘192.0.110.21’ /* IP ADDRESS */
000059 // PORTNO=5001 /* PORT NUMBER */
000060 //PRT420 ENDCNTL
To Next Page
Loading...