Configuring the job computer
Entering field sprayer parameters
Maximum wind speed
Maximale Windgeschwindigkeit
Wind sensor must be installed.
If the maximum wind speed is exceeded, an alarm will be triggered.
Tank size
Size of the tank for the spray liquid.
Tank level alarm
When the volume of spray mixture in the tank falls below this value, an alarm message appears on
the screen.
Pulses main flow
Number of pulses the flow meter sends to the job computer per one liter of liquid. Used to calculate
the application rate.
The number is determined by the flow meter calibration.
Stirring off below
With this parameter, you can set the fill level below which the stirrer should be switched off.
The implement manufacturer (not the user!) can also define whether the stirrer should be switched on
automatically when the job computer is started.
Extremity nozzles set
With this parameter you can specify which extremity nozzles are mounted on the boom. More about
this in section: Extremity nozzles [➙ 70]
Sections switching
Manner in which the sections are switched on and off.
▪ "Sequential mode" [➙ 44]
This type is intended for normal spraying work. It is also suitable for spraying on wedge-shaped
areas and strips that are narrower than the working width of the field sprayer.
▪ "Localized mode" [➙ 45]
This mode is designed for treating weed infestations. Sections can be switched individually and
independently of one another.
Filling mode
With this parameter, you can define whether you want to use TANK-Control for filling.
▪ "Manual" - For field sprayers without TANK-Control.
▪ "TANK-Control" - Activates TANK-Control.
To Next Page
Loading...
Need help?
General
