© Munters AB, 2020 65
o
Close Below This Temp. (out): Inlets close when the outside temperature reaches this
point.
•
Potentiometer-controlled calibration failure: If calibration fails (during auto or power up
calibration) in a potentiometer-controlled calibration, an error symbol appears in the Devices
and Sensor screen.
In this situation, click Calibrate to run the Calibration Wizard. If the calibration fails again, check:
•
Potentiometer wiring
•
Potentiometer
•
Inlets’ and curtains’ opening and closing position. There must be a minumum distance between
the two, equivalent to 300 A2D points.
To Next Page
Loading...
