Description of Setup Buttons (Administrator Settings) 17-13
17
[AE Level Adjustment]
To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [AE Level Adjustment]
Adjust the AE (Auto Exposure) level.
Tap [Higher] or [Lower] to adjust the automatic exposure to one of the five levels. The larger the number, the
darker the background.
[2] is specified by default.
[Printer Adjustment]
To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Printer Adjustment]
Adjust the print start position and defective print images.
[Line Detection] Set this option for the dirt detection level for the Slit Scan Glass and clean-
ing of the Slit Scan Glass.
For details, refer to page 17-27.
[Trail Edge Adjust] Correct the color misalignment if the trailing edge of the printed image is
out of alignment.
For details, refer to page 17-27.
[User Paper Settings] Register special paper with [User Paper 1] through [User Paper 6]. Settings
to configure include Basic Weight and Media Adjustment. For details on
displaying this item, contact your service representative.
[Erase Adjustment] Specify the operation and erase method when erasing the area outside the
original by setting [Non-Image Area Erase].
For details, refer to page 17-28.
[PS Designer Settings] Specify whether to reproduce the colors in the original strictly as they are
when printing it using a PS driver from your computer.
For details, refer to page 17-28.
Settings Description
Settings Description
[Leading Edge Adjustment] Adjust the print start position at the leading edge of the paper relative to
the paper discharge direction.
For details, refer to page 17-14.
[Centering] Adjust the print start position on the left edge of the paper relative to the
paper discharge direction.
For details, refer to page 17-14.
[Leading Edge Adjustment
(Duplex Side 2)]
Adjust the print start position at the leading edge of the back side of the
paper relative to the paper discharge direction for printing the back side in
2-sided printing.
For details, refer to page 17-15.
[Centering (Duplex 2nd
Side)]
Adjust the print start position at the left edge of the paper relative to the
paper discharge direction for printing the back side in 2-sided printing.
For details, refer to page 17-15.
[Erase Leading Edge] Adjust leading edge erase width. For details, contact your service repre-
sentative.
[Vertical Adjustment] Adjust the feed direction zoom ratio of paper types. For details, contact
your service representative.
[Media Adjustment] Adjust print defects (voids, white spots, roughness) that are caused by pa-
per properties for each paper type.
For details, refer to page 17-16.
To Next Page
Loading...
Need help?
General
