Description of Setup Buttons (Administrator Settings) 17-21
17
[2nd Tri-Fold Position Adjustment]
To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Finisher Adjustment]
- [2nd Tri-Fold Position Adjustment]
If the tri-fold positions are not located evenly, use this option to adjust the second fold position.
Copy after configuration, then repeat adjustments as required.
Tips
- This item is available when the Finisher C2280FN2 and Saddle Stitcher C2280SD are installed.
- Make adjustment while checking paper folded at a displaced position.
- The value you set by selecting [All] in [Paper Size] will be added to the setting for each paper size.
Settings Description
[Paper Size] Select the size of paper that is used to adjust the fold position.
[Adjust Value] Enter an adjustment value between -10.0 mm and 10.0 mm by tapping [-]
and [+].
• [-]: Move the fold position to the left.
• [+]: Move the fold position to the right.
[0.0 mm] is specified by default.
To Next Page
Loading...
Need help?
General
