Description of Setup Buttons 15-12
15
[Staple]
To display: [Copy] - [Finishing] - [Staple]
Select the binding positions for sheet stapling.
Tips
- The Finisher is required to use the Staple function.
[Punch]
To display: [Copy] - [Finishing] - [Punch]
Select binding positions when punching sheets.
The number of punched holes varies depending on the country you are in.
Settings Description
[Corner] Each set of printed sheets is stapled in a corner (top left or top right) before
being output.
[2 Position] Each set of printed sheets is stapled at two positions (in the top, left, or
right) before being output.
[Position Setting] Select the binding position and original loading direction. If [Auto] is spec-
ified for the binding position, the binding position is determined automati-
cally based on the direction of the loaded original.
Settings Description
[Position Setting] Select the punch position and original loading direction. If [Auto] is speci-
fied for the punch position, the punch position is determined automatically
based on the direction of the loaded original.
To Next Page
Loading...
Need help?
General
