Manual MVK-MP
6 V 3.5
The power supply must meet the SELV
1
or PELV
2
standards. Power supplies according to EN 61558-2-
6 (transformer) or EN 60950-1 (switch mode power supply) meet these requirements.
System configuration, installation, startup, maintenance, and testing of devices may only be performed
by an accredited, trained electrician familiar with automation technology safety standards.
Current safety and accident prevention laws valid for a specific application must be observed in the
configuration, installation, setup, maintenance and testing of the equipment.
Only cables and accessories are allowed that meet the requirements and regulations for safety,
electromagnetic compatibility and, where applicable, telecommunication transmission equipment and
specifications.
Information regarding which cables and accessories are approved for the installation can be obtained
from your local Murrelektronik branch office, and may also be found in this manual.
Foreseeable misuse
Do not alter the design, engineering, or electrical features of the device.
Do not take out of operation emergency-off functions or equipment. Refer to the relevant
standards, for example, DIN EN ISO 13850 Safety of Machinery - Emergency Stop - Design
Guidelines.
Do not use the device outside of the application fields described in this manual, the Technical
Data, or the Operating Instructions.
Do not use the device outdoors, or in continuous operation in liquids.
Do not clean the device using high-pressure tools.
Do not use the module for climbing.
Qualified Personnel
Requirements to be met by qualified personnel are based on qualification profiles described in ZVEI and
VDM guidelines.
Only qualified electricians that are familiar with the contents of this manual may install and service the
products described: "Weiterbildung in der Automatisierungstechnik" (Further Training in Automation
Engineering), published by ZVEI and VDMA in the Maschinenbau-Verlag, P.O.Box 710864 in D-60498
Frankfurt, Germany.
These are specialists who are capable of assessing the work to be done and the possible dangers on
account of their technical training, knowledge, experience, and konwledge of the relevant standards; or
who have an identical level of knowledge equivalent to technical training since they have worked in the
same area for many years.
Interventions in the hardware and software of our products, if not described in this manual, may only be
carried out by Murrelektronik specialists.
1
SELV:Separated or safety extra-low voltage
2
PELV: Protected extra-low voltage
To Next Page
Loading...
Need help?
General
