74
4-3. Programming with NPST-GR Software
5. Make sure that the source drive and the target drive are specified correctly. The “source drive” shows the
drive which the NPST-GR system disk is in. The “target drive” shows the drive onto which you want to
install NPST-GR.
When the source drive and the target drive are specified correctly, select “YES” and press .
If not, select “NO” and press . You will return to the previous screen.
When you select “YES,” the following screen will appear:
6. Check the message. To install, select “YES” and press . The installation will start.
If you do not want to install, select “NO” and press . You will return to the previous screen.
When the installation is complete, “C:\NPST3” will appear.
Note:
• When NPST-GR is installed successfully, the following files are stored in the NPST3 directory:
NPST.EXE Contains a program which starts NPST-GR.
NPSTE.EXE Contains the system program for NPST-GR.
NPST.HLP Contains help messages.
NPSTP000.CIG Contains information for printer control.
Enter
Enter
The NPST-GR will be installed on drive C.
* Select YES, and the installation will start. *
To Next Page
Loading...
Need help?
General
