10.2 Selection of a standard
Narda FieldMan 101
10.2.1 Standards for HF probes
The HF probes of the FieldMan measure broadband frequencies and cannot be set to a
specific frequency. The measurement result can be displayed as the percentage of the
limit value that has been reached if the frequency of a field source is known or in relation
to the lowest limit value above the frequency of a standard. The settings are made in the
menu under EXPERT SETTINGS.
A selection of predefined standards appears below. The selection options in the Field-
Man may differ from this and depend on the device configuration.
Standard
1)
Frequency range
2013/35/EU LAL 1 Hz to 10 MHz
2013/35/EU HAL 1 Hz to 10 MHz
2013/35/EU Limbs 1 Hz to 10 MHz
2013/35/EU Thermal 100 kHz to 300 GHz
26. BImSchV 2013 (1a) 1 Hz to 10 MHz
26. BImSchV 2013 (1b) 100 kHz to 300 GHz
EMFV 2016 LAL 1 Hz to 10 MHz
EMFV 2016 HAL 1 Hz to 10 MHz
EMFV 2016 Limbs 1 Hz to 10 MHz
EMFV 2016 Thermal 100 kHz to 300 GHz
FCC 96-326 GP 300 kHz to 100 GHz
FCC 96-326 Occ 300 kHz to 100 GHz
GB8702-2014 GP 1 Hz to 300 GHz
ICNIRP 1998 GP 1 Hz to 300 GHz
ICNIRP 1998 Occ 1 Hz to 300 GHz
ICNIRP 2010 GP 1 Hz to 10 MHz
ICNIRP 2010 Occ 1 Hz to 10 MHz
ICNIRP 2020 GP 100 kHz to 300 GHz
ICNIRP 2020 Occ 100 kHz to 300 GHz
IEEE 2019 Unrest NS 1 Hz to 5 MHz
IEEE 2019 Restrd NS 1 Hz to 5 MHz
IEEE 2019 Unrestricted 100 kHz to 300 GHz
IEEE 2019 Restricted 100 kHz to 300 GHz
To Next Page
Loading...
Need help?
General
