7 Device settings
44 FieldMan Narda
7.1 Setting types
On this device, a distinction is made between Device settings and Measurement set-
tings.
7.1.1 Device settings
7.1.2 Measurement settings
7.1.3 Resetting settings
Device settings include all parameters that affect the general device behavior or the form
of the display, but do not affect the measurement itself. The device always remembers
the last used device settings, stores them on the SD card and loads them the next time
the device is started. Device settings, with the exception of EXPERT SETTINGS, are not
saved in a setup.
Open device settings:
⇒ Press SK4.
For information on device settings, see the following sections:
• GENERAL SETTINGS on page 45
• EXPERT SETTINGS on page 47
• POSITION AND TIME on page 48
• CONNECTIVITY on page 50
• INFORMATION on page 51
• SETUPS on page 53
• DATA LOGGER on page 91
These include all parameters that influence a measurement. They are grouped under the
softkey SK2 and are supplemented by the settings under EXPERT SETTINGS (see
7.5 EXPERT SETTINGS on page 47). Only measurement settings are used for saving
and loading a setup.
Open measurement settings:
⇒ Press SK2 in the respective operating mode.
Information on the measurement settings can be found in the description of the respec-
tive operating modes.
Via Factory Reset (see 7.3 GENERAL SETTINGS on page 45), both setting types c
an
be reset to the delivery state.
To Next Page
Loading...
Need help?
General
