NARDA FieldMan User Manual

4.6 Initial commissioning
Narda FieldMan 27
4.6 Initial commissioning
4.6.1 Switch on the device
The device is switched on via the Power key on the left side of the housing.
⇒ Press Power key for > 1 s to switch on the device.
↳ After the system start, the device is ready for operation.
During initial commissioning, then change the following settings if necessary:
• The language of the interface
• Local time
• Time zone (with GNSS option)
• Country of use (for WiFi/Bluetooth option)
4.6.2 Selecting the language of the interface
1. Press SK4 to open the device settings.
2. Under GENERAL SETTINGS > Language, select the language
(see 7.3.1 DISPLAY on page 45).
4.6.3 Setting the local time and time zone
1. Press SK4 to open the device settings.
2. Under POSITION AND TIME > DATE / TIME > Time, set the time,
under... > Time Zone, set the time zone (see 7.6.3 DATE / TIME on page 49).
NOTICE
Damage to a device covered in dew during commissioning
A device stored or transported at low temperatures may become covered in dew
when brought into a warm room. If it is put into operation in this condition, it may
be damaged.
⇒ To prevent damage, wait until all dew on the surface of the device has evaporated.
⇒ The device is not ready for operation until it has reached the operating range of ‒20
to +50 °C.

NARDA FieldMan Specifications

General

Brand	NARDA
Model	FieldMan
Category	Measuring Instruments
Language	English