10.4 Commenting on measurement results
Narda FieldMan 103
10.4 Commenting on measurement results
✓ DEVICE SETTINGS > GENERAL SETTINGS
⇒ See 7.3.2 SAVE OPTIONS on page 46.
In this menu you can set whether a comment is to be recorded with the saving of mea-
surement results via voice or text input. Both functions can also be activated.
If the respective type of comment is activated and a measurement result (not a screen-
shot) was saved via the save key, the menu navigation for the voice comment opens first
and then the menu
navigation for the text input via the editor. In the TIMER LOGGING
operating mode, the prompt for entering a voice or text comment already appears after
pressing Enable Timer, i.e. before the actual start of measurement.
10.4.1 Activating voice comments
10.4.2 Activating text comments
Text comments and voice comments can also be added or changed at any time later
in DATA LOGGER.
Activate voice comments:
1. Add Voice Comment = On
2. Return to the measuring interface.
Enter a voice comment:
⇒ See 9.3.3 Adding a voice comment on page 95.
For simplified text input, a predefined text (Default Text) can be used and added to
during input.
Activate text comments:
1. Add Text Comment = On
2. Edit Default Text if necessary.
3. Return to the measuring interface.
Enter a text comment:
⇒ See 9.3.2 Adding a text comment on page 95.
To Next Page
Loading...
Need help?
General
